Value of PIN of GSM gate set from production and after initialization is 0000. PIN 0000 shall not be set into cell phone from gate so that blockage of phone is not caused during first contacts with gate.
Example:
Original PIN of GSM gate is 0000. SIM card, which you use in cell phone in GSM gate has PIN 1234 and is blocked by PIN.
Insert the SIM card into the mobile phone, but do not connect the GB 051 connector yet. Insert the required PIN in the mobile phone (e.g. 1234). Go into the mobile phone menu and select Settings – Security – Codes – Change PIN then insert the old PIN and the new PIN according to the mobile phone instructions.
Send a command SMS message with text XX0000PINV1234 from cell phone or Internet on cell phone number in the unit.
As soon as a confirmation SMS message comes back to sender’s cell phone the new PIN is set to value “1234”
User can verify the PIN change by switching the phone off.
Initialization:
In case you forget current PIN of GSM Remote Supervision you have no choice than to carry out initialization of parameters to original
1.Disconnect external power supply. (throw up power adapter)
2.Disconnect the mobile phone connector.
3.Interconnect inputs GROUND and INIT (terminals No. 1 and 2, see Chapter 3.2.) on terminal board
4.Connect external power supply. (throw in power adapter)
5.Remove connection GROUND – INIT
6.Disconnect external power supply. (throw up power adapter)
7.Connect the mobile phone to the GB 051 unit – the PIN must be preset to value “0000”.
8.Connect external power supply.
9.PIN and other required parameters have to be
4.2.RESET of GSM Remote Supervision
If you want to carry out remote reset of counters of days and months in operation then send SMS message with Command RESET. Command is rejected if GB 051 runs from backup battery.
Command | XXppppRESET |
Pppp | Four digits of current PIN |
Function is equivalent to disconnection of gate from power supply (also backup one) and its
11