Car stereo without ISO connectors
•To simplify the wiring procedure, you will need to purchase an ISO adapter cable.
•Refer to the range of ISO adapters on our website: www.parrot.com
Installing the kit’s power cable
•Refer to your car stereo’s wiring diagram.
•The red wire of the kit’s cable must correspond to the constant +12V supply, the orange wire to the ignition +12V and the black wire to ground.
•Check that the orange wire is not connected to the constant +12V supply, as you could run down the vehicle’s battery, preventing your
•On some vehicles, the red and orange power supply wires may need to be reversed. This can easily be done by reversing the two fuse holders on the Parrot MK6100 installation cable.
Note: on some vehicles, there is no ignition +12V on the vehicle’s connectors. You must therefore connect the orange power supply wire to the fuse box or another ignition power source.
Checking the wiring
•When you switch off your vehicle’s ignition, you should see «Goodbye» on the Parrot MK6100 screen.
Otherwise, the ignition +12V and the constant +12V supply have been reversed. In this case, reverse the two fuse holders on the kit’s power supply lead.
Choose the place for the control screen inside your vehicle. We would advise you to fit it in the centre of the dashboard or near you. You can place the wireless controls either on the dashboard or the steering wheel. Ensure that you place them within easy reach.
IMPORTANT: if you place them on the steering wheel, make sure that they are securely attached, so that they do not move when you are driving. Do not install the controls on the outside of the steering wheel, so that they do not get in the way when driving.
Installing the Parrot MK6100 Screen
There are two different ways to install the
Parrot MK6100 screen.
The first way lets you place the screen against the dashboard.
•Stick the
• Then insert the screen into its connector.
Double sided tape
14 | Parrot MK6100 |