Sharp DK-KP95PH Advanced CD or MP3/WMA disc playback, Repeat play, Random play shuffle

Advanced CD or MP3/WMA disc playback (continued)

A. For example, to choose 13

1	Press the “10+” button once.
2	Press the “1” button.
3	Press the “3” button.	Selected track number

B. For example, to choose 130

1Press the “10+” button twice.

2Press the “1” button.

3Press the “3” button.

4Press the “0” button.

Notes:

●A track number higher than the number of tracks on the disc cannot be selected.

●During random play, direct search is not possible.

To stop playback:

Press the (CD ) button.

■Repeat play

Repeat play can play one track, all tracks or a programmed sequence continuously.

To repeat one track:

Press the PLAY MODE button repeatedly until “Repeat One” appears. Press the / (CD /) button.

To repeat all tracks:

Press the PLAY MODE button repeatedly until “Repeat All” appears. Press the / (CD /) button.

To repeat desired tracks:

Perform steps 1 - 5 in “Programmed play” section on this page

12and then press the PLAY MODE button repeatedly until “Repeat All” appears.

To cancel repeat play:

Press the PLAY MODE button repeatedly until “Normal” appears and “ ” disappears.

Caution:

After performing repeat play, be sure to press the (CD ) button. Otherwise, the disc will play continuously.

■Random play (shuffle)

The tracks on the disc can be played in random order automatically.

To random play all tracks:

Press and hold the PLAY MODE button on the remote control until “Random” appears. Press the / (CD /) button.

To cancel random play:

Press the PLAY MODE button again. “RDM” indicator will disappear.

Notes:

●If you press the button during random play, you can move to the track selected next by the random operation.

On the other hand, the button does not allow you to move to the previous track. The beginning of the track being played will be located.

●In random play, the unit will select and play tracks automatically. (You cannot select the order of the tracks.)

■Programmed play (CD)

You can choose up to 32 selections for playback in the order you like.

1While in the stop mode, press the MEMORY button on the remote control to enter the programming save mode.

2Press the Numeric buttons on the remote control to select the desired track.

Note: To select track number 10 or higher, refer ’Direct track search’ on page 11.

Selected track number

3Repeat step 2 for other tracks. Up to 32 tracks can be programmed. If you want to check the programmed tracks, press the MEMORY button repeatedly. If you make a mistake, the programmed tracks can be cleared by pressing the CLEAR button.

4Press the / (CD /) button to start playback.

■Programmed play (MP3/WMA)

1While in the stop mode, press the MEMORY button to enter the programming save mode.

2Press the PRESET ( or ) button on the remote control to select the desired folder.

Then press Numeric buttons on the remote control to select the desired tracks.

Note: To select track number 10 or higher, refer ’Direct track search’ on page 11.

3Repeat step 2 for other folder/tracks. Up to 32 tracks can be programmed.

4Press the / (CD /) button to start playback.

To cancel the programmed play mode:

During programmed stop mode, press the (CD ) button. The display will show “Memory Clear” and all the programmed contents will be cleared.

Adding tracks to the programme:

If a programme has been previously stored, the “MEM” indicator will be displayed. Press the MEMORY button. Then follow steps 2 to add tracks.

Notes:

●When the disc compartment is opened, the programme is automatically cancelled.

●If you press the ON/STAND-BY button to enter the stand-by mode or change the function from CD to another, the programmed selections will be cleared.

●During the programme operation, random play is not possible.

E-12