Sharp DK-KP95PH operation manual Maintenance, Specifications

Troubleshooting chart (continued)

		NO
■	Before transporting the unit

Remove the iPod, iPhone, iPad, USB memory device and disc from the unit. Then, set the unit to the power stand-by mode. Carrying the unit with iPod, iPhone, iPad or USB memory device left connected or discs left inside might damage the unit.

YES Correct

■Care of compact discs

Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player.

●Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface.

●Keep your discs away from direct sunlight, heat, and excessive moisture.

●Always hold the CDs by the edges. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius.

Maintenance

■Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth.

Caution:

●Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet.

●Do not apply oil to the inside of the unit. It may cause malfunctions.

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

■General

Power source	AC 220 - 240 V ~ 50/60 Hz
Power	Power on: 26 W
consumption	Power stand-by: 0.4 W (*)
Speaker	1-way speaker system
	Speaker: 6.5 cm (2-1/2")
Speaker	50 W/channel
maximum input
power
Speaker rated	25 W/channel
input power
Dimensions	Width: 475 mm (18 - 11/16")
	Height: 191 mm (7 - 1/2")
	Depth: 83 mm (3 - 1/4")
Weight	2.7 kg (5.9 lbs.)

( * ) This power consumption value is obtained when the demonstration mode is cancelled in the power stand-by mode. Refer to page 4 to cancel the demonstration mode.

■ Amplifier

Output power	PMPO: 100 W
	MPO: 50 W (25 W + 25 W)
	(10% T.H.D.)
	RMS: 50 W (25 W + 25 W)
	(10% T.H.D.)
	RMS: 40 W (20 W + 20 W)
	(1% T.H.D.)
Output terminals	Headphones: 16 ohms
	(recommended: 32 ohms)
Input terminals	Audio In (audio signal):
	500 mV/47 k ohms

■CD player

Type	Single disc multi-play compact disc
	player
Signal readout	Non-contact, 3-beam
	semiconductor laser pickup
D/A converter	Multi bit D/A converter
Frequency	20 - 20,000 Hz
response
Dynamic range	90 dB (1 kHz)

■USB (MP3 / WMA)

USB host interface	● Complies with USB 1.1 (Full
	Speed)/2.0 Mass Storage
	Class.
	● Support Bulk only and CBI
	protocol.
Support file	● MPEG 1 Layer 3
	● WMA (Non DRM)
Bitrate support	● MP3 (32 ~ 320 kbps)
	● WMA (64 ~ 160 kbps)
Other	● Maximum total number of
	MP3/WMA files is 65025.
	● Maximum total number of
	folders is 999 INCLUSIVE of
	root directory.
	● The ID3TAG information
	supported are TITLE, ARTIST
	and ALBUM only.
	● Supports ID3TAG version 1
	and version 2.
File system	● Support USB devices with
support	Microsoft Windows/DOS/FAT
	12/FAT 16/ FAT 32.
	● 2 kbyte block length for sector.

■ Tuner

Frequency range	FM: 87.5 - 108 MHz
	AM: 522 - 1,620 kHz
Preset	40 (FM and AM station)

E-22