OPERATIONAL INSTRUCTIONS
GENERAL PRECAUTIONS
1.Use the lowest holes in the PIVOT ARMS(91) until you become familiar with the Elite Inversion System.
2.Do not use the Elite Inversion System alone. Always have a helper available in case assistance is needed in recovering from the decline position.
3.Make sure that the FOAM PADS(18) and HEEL HOLDERS(15) are holding your feet securely.
4.Make sure that the HEIGHT ADJUSTMENT BEAM(10) is properly set for your height.
5.Make sure that the HEIGHT ADJUSTMENT BEAM(10) is held securely by both the SPRING PIN(35) and the LOCKING KNOB(36).
6.Make sure that there is enough room for the bed to rotate completely.
HEIGHT ADJUSTMENT
The Elite Inversion System is a very sensitive balance device. It responds to very slight changes in weight distribution. It is very important to make sure that the height adjustment is adjusted properly. Use the following procedure to set the height adjustment and balance the Elite Inversion System.
1.Insert the PULL PINS(86) into the second adjustment holes from the top in the ANGLE ADJUSTMENT BARS(85) to restrict the movement of the NYLON BED(37) to the least amount of inversion angle. The PULL PINS(86) should not be inserted into the lowest adjustment holes in the ANGLE ADJUSTMENT BARS(85), or the Elite Inversion System may go into the full inversion position while you are setting the height adjustment.
2.Loosen the LOCKING KNOB(36) under the
MAIN FRAME(92).
3.Pull the SPRING PIN(35) and use the SCALE INDICATION to set the HEIGHTADJUSTMENT
BEAM(10).
4.Tighten the LOCKING KNOB(36).
5.Mount the machine.
6.Lock your ankles into the FOAM PADS(18) and
HEEL HOLDERS(15).
7.Lie back with your hands at your sides.
8.Slowly raise your hands to your chest.
9.If your feet are higher than your head, dismount and try a taller setting. If you do not rotate to a position close to level, dismount and try a shorter setting.
NOTE: The Elite Inversion System should return to the upright position when your hands are below your waist. If it does not, use a taller setting.
11