HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
| 3/16" |
| 1/4" | 5/16" |
| 3/8" |
| 1/2" |
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
| INCHES |
|
|
| |
0 | 1/2 |
| 1 | 1/2 | 2 | 1/2 |
| 3 | 1/2 | 4 | 1/2 | 5 | 1/2 | 6 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| in. |
0 | 10 | 20 | 30 | 40 | 50 | 60 | 70 | 80 | 90 | 100 | 110 | 120 | 130 | 140 | mm. |
150 | |||||||||||||||
MILLIMETERS length
6 8 10 12
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw. length Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware may be already attached to the part.
Part No. and Description | Qty | |
59 | Bolt, Button Head (M6 x 1 x 35mm) | 1 |
60 | Bolt, Button Head (M6 x 1 x 47mm) | 1 |
62 | Bolt, Button Head (M8 x 1.25 x 15mm) | 4 |
63 | Bolt, Button Head (M8 x 1.25 x 50mm) | 2 |
64 | Bolt, Button Head (M8 x 1.25 x 55mm) | 2 |
79 | Bolt, Button Head (M10 x 1.5 x 60mm) | 2 |
66 | Nylock Nut (M6 x 1) | 1 |
67 | Nylock Nut (M8 x 1.25) | 2 |
80 | Nylock Nut (M10 x 1.5) | 2 |
68 | Washer (M6 x ø16 x 1.5mm Thick) | 2 |
69 | Washer (M8) | 8 |
81 | Washer (M10) | 4 |
70 | Arc Washer (M8) | 2 |
71 | Arc Washer (M6) | 1 |
5