Pivot ARM Adjustment | Stamina Products 55-1537C specification

ASSEMBLY INSTRUCTIONS

A	B
	B
	C

STEP 3

Slide the bottom of the two PIVOT ARMS(91) into the brackets located at each side of the MAIN FRAME (92). Align the desired hole on the arm with the peg on the bracket, then insert the peg into the hole to lock the PIVOT ARMS(91) in position. Secure the PIVOT ARMS(91) with the SECURING KNOBS (3/8"-16 x 1/2")(93) on the inner side of the brackets.

PIVOT ARM ADJUSTMENT:

There are three adjustment holes on the PIVOT ARMS(91) allowing you to position the MAIN FRAME(92) at three different heights. The lowest hole will allow the least amount of inversion angle. The top hole will allow the greatest amount of inversion angle.

CAUTION: 1. Use the lowest holes in the PIVOT ARMS(91) until you become familiar with the Elite

Inversion System

2.Both PIVOT ARMS(91) must be adjusted to the same hole. Trying to adjust the PIVOT ARMS(91) to different positions could cause damage to the machine, and injury to the user.

STEP 4

Attach the MAIN FRAME(92) onto the REAR FRAMES(2, 3) by sliding the slots in the ends of the two PIVOT ARMS(91) into the slots on the REAR FRAMES(2, 3) and secure with the SHAFT CLIPS (43, 44).