Stamina Products 55-1537C owner manual Assembly Instructions

Page 8

ASSEMBLY INSTRUCTIONS

STEP 5

Attach the ANGLE ADJUSTMENT BARS(85) onto the shafts on both sides of the MAIN FRAME(92) with BOLTS(M8 x 15mm)(62) and WASHERS(M8)(69). Do not tighten the bolts until STEP 6.

STEP 6

Slide one of the SUPPORT SLEEVES(84) onto the left ANGLE ADJUSTMENT BARS(85). Install the SUPPORT SLEEVES(84) onto the shaft on the LEFT FRAME(2) with the SUPPORT SLEEVE(84) above the shaft as shown in the illustration, and secure with a BOLT(M8 x 15mm)(62) and WASHER(M8) (69). Insert the PULL PIN(86) into one of the Adjustment Holes in ANGLE ADJUSTMENT BAR(85). Repeat on the other side. Tighten all the bolts.

8

Image 8
Contents Stamina Products Table of Contents Safety InstructionsCall US First Before YOU Begin Inversion SystemHardware Identification Chart Assembly Instructions StepPivot ARM Adjustment Assembly Instructions Assembly Instructions Assembly Instructions Operational Instructions General Precautions Height AdjustmentMain FRAME92 Heel HOLDERS15Operational Instructions Inversion Angle Adjustment Heel Holder USE and AdjustmentHandrails Foam PADS18Operational Instructions Using the PRO Inversion System Locking the BED Recovery from Locked PositionOperational Instructions Suggestions for USE Maintenance StorageProduct Parts Drawing BackDIAGRAM# Part Name QTYDIAGRAM# Part Name QTY Warranty Limited WarrantyPage Page FAX/MAIL Ordering Form Telephone FAX Online Mail