Assembly Instructions

STEP 10

Install the HEIGHT ADJUSTMENT BEAM(10) into MAIN FRAME(92) by pulling the SPRING PIN(35) on the MAIN FRAME(92) and inserting the HEIGHT ADJUSTMENT BEAM(10) as shown. For added safety, thread the LOCKING KNOB(3/8"-16 x 3/4")(36) into back side of the MAIN FRAME(92).

WARNING: Do not use the Elite Inversion System until you have verified your height setting. Failure to use the proper height setting can result in difficulty recovering from the decline position. See HEIGHT ADJUSTMENT instructions on page 11.

STEP 11

Insert the front ends of the HANDRAILS(5) onto the short tubes on REAR FRAMES(2, 3). Then attach the back ends of the HANDRAILS(5) with BOLTS(M8 x 50mm)(63) and WASHERS(M8)(69).