ASSEMBLY INSTRUCTIONS
STEP 7: Attach the FOOTREST(11) onto the HEIGHT ADJUSTMENT BEAM(10) with the adjustment holes facing down. Secure the FOOTREST(11) in place with the ADJUSTMENT KNOB(12).
NOTE: The four adjustment holes in the FOOTREST(11) allow the FOOTREST(11) to be attached in four different positions. Start with one of the center positions and adjust if necessary. Use the outer position if users are taller than average. Use the inner position if users are shorter than average.
STEP 8
Insert the HEEL HOLDER TUBE(13) through the hole on the HEIGHT ADJUSTMENT BEAM(10) and secure with BOLT(M6 x 47mm)(60), WASHERS(M6 x ø16 x 1.5mm Thick)(68), and NYLOCK NUT(M6)(66). Place a HEEL HOLDER BRACKET(14) onto a HEEL HOLDER(15), then slide them onto the HEEL HOLDER TUBE(13) together. Repeat on other side.
STEP 9
Insert the OUTER PAD TUBE(17) through the hole on the HEIGHT ADJUSTMENT BEAM(10). Insert the INNER PAD TUBE(16) into the OUTER PAD TUBE(17). Align the holes on the INNER PAD TUBE(16), OUTER PAD TUBE(17), and HEIGHT ADJUSTMENT BEAM(10), then bolt them together with BOLT(M6 x 35mm)(59) and ARC WASHER(M6)(71).
WARNING: The PAD TUBES(16, 17) must be assembled with the ends pointed downward as shown. The ends must be pointed downward to properly secure the users feet in place during inversion. Improper assembly will allow the user's feet to come loose and the user will fall from the Elite
Inversion System.
9