Coleman 5178 Series manual To Light, English-3, Remove lantern parts from package

Page 4

Remove lantern parts from package.

Igniter Electrode

 

Ventilator-Bail

 

Lantern Frame

Assembly

 

 

Globe

 

Base

 

 

Ball

 

Mantles

 

 

Nut

 

 

WARNING

Replace any mantle with a hole in it. A hole can cause lantern to overheat and create a hazard. Never operate lantern without heat shield.

Note: Use Coleman 16.4 oz. disposable propane cylinders. The LP-gas cylinder(s) used with lanterns must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation or Transport Canada, CAN/CSA B339.

Always use genuine Coleman® #21 size mantles. If using Insta-Clip® II tabbed mantles, follow the instructions on the mantle package.

Place lantern frame in base.

If using tie style mantles, tie mantles around grooves in burner. (Fig. 1)

Distribute folds on mantle evenly. Cut off surplus string 1/4" (0.6cm) from knot. (Fig. 2)

For INSTASTART™ electronic ignition lanterns, be careful that mantle does not snag

on electrode.

Take lantern outdoors away from

ignition sources.

Turn fuel valve off. (Fig. 8)

Fig. 8

Remove protective cap from top of propane cylinder. Save cap for use in storing. (Fig. 9)

Fig. 1

Fig. 2

DANGER

• EXPLOSION - FIRE HAZARD

• Propane is heavier than air and can accumu-

late in low places. If you smell gas, leave the

Light bottom of mantle evenly. Burn until nothing but white ash remains. Once the mantle has been burned, it is very fragile. Be careful not to touch it with finger or match. (Fig. 3, 4)

area immediately.

• Always attach or detach propane source out-

doors; never while lantern is lighted, near

flame, pilot lights, other ignition sources or

Fig. 3

Fig. 4

while lantern is hot to touch.

• Always light & use lantern outdoors.

• This lantern must not be exposed to flamma-

ble vapors or liquids during lighting.

• This lantern is red hot during use and can

ignite flammables too close to the mantles.

Keep flammables at least 12 inches from the

sides and 48 inches from the top of the

lantern. Keep gasoline and other flammable

Complete assembly. (Fig. 5, 6, 7)

liquids and vapors well away from lantern.

Fig. 5

Fig. 6

Fig. 7

Screw propane cylin- der into lantern. Take care not to cross-thread. Hand tighten only.

(Fig. 10)

Set lantern into base. (Fig. 11)

To Light

WARNING

If you smell gas:

1.Do not attempt to light appliance.

2.Extinguish any open flame.

3.Disconnect from fuel supply.

4.Call 1-800-835-3278.

English-3

Image 4
Contents Series English-1 California PropositionTo Set Up Technical CharacteristicsEnglish-2 To Light English-3Remove lantern parts from package Propane is heavier than air and can accumuTo Store English-4Warranty English-5For products purchased in the United States For products purchased in CanadaAccessories sold separately Parts ListEnglish-6 Pour Votre Sécurité Français-1Français-2 Risque D’EXPLOSION ET D’INCENDIERisque DE Brûlure Risque D’INTOXICATION OxycarbonéeAllumage AssemblageFrançais-3 Français-4 Extinction RangementRenseignements essentiels Français-5Français-6 Garantie’envoyez pas de produits dont le réservoir Nomenclature Accessoires vendus séparémentFrançais-7 Para SU Seguridad Español-1Explosión Peligro DE Incendio Español-2Peligro DE Quemaduras Características Técnicas Para ArmarEspañol-3 Peligro DE Monoxido DE CarbonoPara encender Español-4Explosión Riesgo DE Fuego El propano es más pesado que el aire y sePara apagar Español-5Cosas que Debe Saber Español-6Durante el funcionamiento, lleve la lámpara por el asa Para los productos comprados en los Estados UnidosEspañol-7 GarantiaMississauga, Ontario Canada L5R Lista de Piezas Accesorios se venden por separadoEspañol-8 DescripciónPage 5178-050T 11/17/05