32
SMOOTH 9.15HR POWER FOLDING TREADMILL
TROUBLESHOOTING
Troubleshooting
NOTE: Do not touch any internal electric wires without consulting the manufacturer.
No display on the Computer LED, after the power is switched on:
1.Make sure the power cord has been plugged in properly to the power switch on the base frame and mains power socket.
2.Make sure the safety key is inserted properly into the safety key slot on the console. Try pulling it in and out several times until the LED lights up.
Treadmill will not fold up:
1.If the incline level is above level 0, press the Reset button on the computer. The treadmill incline level should return to level 1 and stop. Then please follow the Power Fold Instructions in this manual to complete the fold up operation.
2.If the incline has been lowered to level 0, but you cannot lock the spring load knob, please turn the spring load knob clockwise. Then lift the treadmill frame from the rear end slightly and check if the spring load knob can be locked in. If you can lock in the spring load knob, then your treadmill is not on a level surface. Please check if both rear wheels are sitting on the floor evenly, or follow the Level Adjustment Instructions in this manual to adjust the level adjusters underneath the base frame until both rear wheels sit evenly on the floor and the spring knob can be locked in.
Computer LED does not show the pulse:
1.First, please press the Start button to start the treadmill. Place both hands on the heat rate contact sensors on the handlebars. Then check if the LED shows a blinking heart symbol. If the blinking heart symbol is displayed then the computer is sensoring your pulse properly. Keep your hands on the sensors until the actual pulse number is displayed on the LED.
2.If when holding the contact sensors on the handlebars the heart symbol is not displayed, please disassemble the handlebars and check to make sure both sensor wires are assembled correctly. Disconnect and then reconnect them again. Then try the heart rate contacts again.
Treadmill will not start:
1.Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly grounded outlet and the surge protector is turned on (refer to the Power Requirements section in this manual).
2.Check the circuit breaker reset switch located on the front of the treadmill. Turn the power off, wait 5 minutes then press the rest switch.
3.Check the house electrical breaker box and the circuit breaker for the room the treadmill is located in. If it has tripped, reset or have an electrician replace the breaker in home.
4.Have an electrician check for inadequate voltage at the outlet.
Visit us at: www.smoothfitness.com