ERROR CODES
CHAPTER NINE: CARE AND MAINTENANCE
E1:INCLINE | Incline moving when not commanded to. |
E1:RANGE | Difference between zero position and |
| maximum incline not sufficient. |
E1:STALL | Incline not moving when commanded to. |
E2:OVERSPEED | This error occurs when an acceleration of |
| greater than 2.1 mph occurs. Error cleared |
| by turning off power switch then turning |
| it back on. |
E2:CAL | Treadmill cannot achieve target speed. |
| |
E3:RECAL | This error occurs when a data error is |
| detected in the EEPROM. Replace the |
| control panel. |
E4:KEY STK [stop] Caused by pressing and holding the stop key for more than five seconds.
E5:SENSOR | This message is displayed when there is |
| no speed feedback. |
All errors require service by a qualified technician in order to clear the error, turn power off and back on again.
ERROR CODES
ES TREADMILLS OWNER’S GUIDE | 68 |
|