Aiwa NSX-A303, NSX-A304 manual Inserting Blank Spaces, Insert the tape to be recorded on into deck

This section explains how to record from the tuner, CD player, or external equipment.

2 t+

~*.;a.,mm,d*mx,r*cm%@’*w XF%.=kee.,, *W. ,.. ~~ax=.~~ *g,*>q,$~~r4.J,* wLw$,,”%, .,*,W $3$%W%W-W$

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables you to activate the Music Sensor function. (Applicable when the source is TUNER,

VIDEO/AUX or MD.)

1 Press ● REC/REC MUTE during recording or while in recording pause mode.

~on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode.

2Press II to reeume recording.

To insert a blank space of less than 4 seconds, press ●

REC/REC MUTE again while ~ is flashing.

To insert blank spacee of more than 4 seconds, after the deck enters recording pause mode, press ● REC/REC MUTE again. Each time the button is pressed, a 4-second blank space is added.

- —,_,,,,,, ,,.

Preparation

“Use Type I (normal) tapes only.

● Set the tape to the point where recording will start.

● Note that recording is done on only one side of the tape.

1 Insert the tape to be recorded on into deck 2.

Insert the tape with the side to be recorded on first facing out from the unit.

A EJECT

I 1 J

2 Press function (CD, TUNER or VIDEO/AUX) and prepare the source to be recorded.

To record from a CD, press CD and load the disc(s).

To record from a radio broadcast, press TUNER and tune

in to a station.

To record from a connected source, press VIDEO/AUX and

play.

3 Press ● REC/REC MUTE to start recording.

When the selected function is CD, playback and re=ording start simultaneously.

To stop recording, press ■ .

To psuse recording, press II. (Applicable when the source is TUNER or VIDEO/AUX) To resume recording, press it again.

Sound adjustment during recording

The output volume and tone of the speakers or headphones may be freely varied without affecting of the recording.

>

About cassette tapes

●To prevent accidental erasure, break off the plastic tabs on the cassette tape after recording with a screwdriver or other pointed tool.

Side A

To record on the tape again, cover the tab openings with adhesive tape, etc.

●120-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended.

●Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism.

To erase a recording

1 Insert the tape to be erased into deck 2 and press TAPE/ DECK 1/2 to display “TP2.

2Set the tape to the point where the erasure is to be started.

3Press ● REC/REC MUTE to start the erasure.

I I ENGLISH