Aiwa CX-NA303, NSX-A303, NSX-A304 manual Electric Power, AC power cord

Page 2

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIDE

REFER SERVICING TO QUALIFIED

SERVICE PERSONNEL.”

Owner’s record

For your convenience, record the model number and serial number (you will find them on the rear of your set) in the space provided below. Please refer to them when you contact your Aiwa dealer in case of difficulty.

Model No.

Serial No. (Lot No.)

CX-NA303

SX-NA302

SX-R275 (NSX-A304 only)

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1 Water and moisture — Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat — Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 “F)or greater than 35°C (95°F).

3Mounting surface — Place the unit on a flat, even surface.

4Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry — Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands — When placed or mounted on a stand or cart, the unit should be moved with care.

Quick stops, excessive force, and

uneven surfaces may cause the&&* @!!!I!

unit or cart to overturn or fall.

7 Condensation — Moisture may form on the CD pickup lens when;

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8 Wall or ceiling mounting —The unit should not be mounted

on a wall or ceiling, unless specified in the Operating Instructions.

Electric Power

1 Power sources — Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.

2 Polarization — As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cords should be firmly secured to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power outlet.

-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock.

1 ENGLISH

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Call toll free I-800-BUY-AIWA Digital AijdioElectric Power AC power cordSetting the Clock Setting the Sleep Timer Setting the Timer Audio Adjustments Graphic EqualizerManual Tuning Presetting Stations Connecting Optional Equipment Listening to External SourcesConnect the right and left speakers to the main unit Before connecting the AC cordCheck your system and accessories INSX-A3041Connect the AC cord to an AC outlet Connecting AN Outdoor AntennaConnect the supplied antennas AM antennaTo use Function on the remote control When to replace the batteriesTo use Shift on the remote control To turn the power offUsing the headphones To select with the remote controlTo cancel the selected mode Sound adjustment during recordingRepeat steps 1 Press TUNER/BAND repeatedly to select the desired bandPress + Down or W UP to select a station Press Tape and press a Eject to open the cassette holder Press to start playTo plav all discs in the disc com~artment, press To start play when the power is off Direct Play FunctionSelecting a track with the remote control To sesrch for a particular point during playback, keep +Press Disc Direct Play 1-3 to select a disc Press Prgm while pressing Shift in stop modePress numbered buttons O-9 and +10 to program a track Press REC/REC Mute to start recording Inserting Blank SpacesInsert the tape to be recorded on into deck To stop dubbing Press . REC/REC Mute to start recordingPress Sync Dubbing to start recording Press REC/REC Mute to start recording on the first side ‘MlInsert the tape into deck Repeat step For Rest Tracks for Side Ill ~miij To change the program of each sidePress Down or UP to designate the minute, then press II SET Press CLOCK, then press II SET within 4 secondsPress + Down or UP to designate the hour, then press II SET Pressing Down or UP, then press Repeat to designate the minute of the timer-on timePrepare the source Press Function to select a source, then pressVIDEO/AUX Jacks When connecting a turntableWhen the CD Digital OUT Optical jack is not being CD Digital OUT Optical JackCassette Deck Section GeneralTuner Section CD Player SectionCopyright Page Espanol Sintonizacion PrecaucionesAntes DE LA Operacion PreajusteSurround Speakers R O L Antes de conectar el cable de alimentacion de CACompruebe su sistema y Ios accesorios Para posicionar Ias antenas Antena de FM Conecte Ias antenas suministradasiConecte el cable de alimentacion de CA a una toma de CA Para conectar otro equipo optional -+ paginaJueao de demostracion Para cancelar el modo DemoPara encender la unidad Para reducir la intensidad de iluminacion del visualizador Para cancelar el modo seleccionadoPara seleccionar con el control remoto Pulse un Graphic EqualizerPara buscar rapidamente una emisora btisqueda automatic Pulse + Down 0 UP para seleccionar una emisoraRepita Ios pasos 1 y Cuando una radiodifusion estereo por FM tenga ruidoSintonizacion Mediante Numero DE Preajuste Para retxoducir un disco solamente, pulse Disc Direct Play Reproduction DE DiscosPara reproducer todos Ios discos del compartimiento, pulse JOGPulse Disc Direct Play 1-3 para seleccionar un disco DE ReproductionModo de parada Programar una cancionPulse REC/REC Mute para iniciar la grabacion Insercion DE Espacios SIN GrabarInserte la cinta que vaya a grabar en la platina Pulse II para reanudar la grabacion+-- Y PulseTAPE/DECK 1/2 para seleccionar la platinaPara detener la grabacion Inserte la cinta en la platinaREC/REC Mute para iniciar la grabacion de la segunda cara Para borrar el programa de editionProgramadas Para detener la qrabacionPara comprobar el orden de Ios numeros de Ia.ecanciones Para cambiar el programa de cada caraCuando se utilice el control remoto Para cancelar el temporizador para dormirRELOJ?@#ADOR -.=.!% Para cambiar al modo de 24 horasPara comprobar la hors y la fuente de sonido especificadas Pulse Timer para visualizer 0, y Iuego pulseHaber ajustado el volumen y el tono Cuando conecte un giradiscos Pulse VIDEO/AUXHaga la reproduction en el equipo conectado Cuando no se utilice la toma CD Digital OUT OpticalSeccion DE LA Platina Derechos DE Autor Page Entree d’objets et de Iiquide Faire attention a ce que InstallationReleve du proprietaire Chariot et support Si I’appareilLecture DE Cassettes PreparationsReception Radio Lecture DE DisquesContr61er la chaine et Ies accessoires Avant de brancher Ie cordon secteurBrancher Ie cordon secteur a une prise de courant Connexion D’UNE Antenne ExterieureConnecter Ies antennes fournies Pour connecter un appareil optionnel +Mode Demo Demonstration Utilisation de Shift de la telecommandeUtilisation de Function de la telecommande Pour annuler Ie mode DemoVolume Appuyer sur II SET pour memoriser la station Appuyer sur TUNER/BAND a plusieurs reprisesAppuyer surTUNER/BAND pour selectionner une Repeter Ies etapes 1 etAccord SUR UNE Station Memorisee Appuyer sur ~ pour demarrer la lectureChangement de disques pendant la lecture Selection d’une plage avec la telecommandePour verifier Ie temps restant Pour Iire un ou deux disaues, mettre Ies disques sur IesShift Appuyer sur Recirec Mute pour demarrer ’enregistrement Insertion D’ESPACES BlancsInserer la cassette a enregistrer clans la platine Appuyer sur TAPE/DECK 1/2 pour selectionner la platine Appuyer sur Sync Dubbing pour demarrer l’enregistrementPour effacer Ie programme du montage Inserer la cassette clans la platinePour arri+ter I’enregistrement Duree des cassettes et temps du montagePour changer Ie programme de chaque face Repeter ’etape Pour Ie reste Des plages De la FacePour contr61er I’ordre des numeros des plage!s programmers Appuyer sur EDIT/CHECK tout en appuyant sur Shift de laRegler Iei- m-inutes, puis appuyer sur II ‘SET p-our Ies reglerPour ecouter un disaue com~act, mettre Ie disque Pour annuler provisoirement Ie mode attente de minuteriiePreparer la source Pour ecouter une cassette, la mettre en place clansPour connecter un tourne-disque Prise CD Digital OUT OpticalAppuyer sur VIDEO/AUX Blanche a la prise VIDEO/AUX LPartie Magnetocassette Droits D’AUTEUR Page Page Page Page/Pagina/Page

CX-NA303, NSX-A304, NSX-A303 specifications

The Aiwa NSX-A303, NSX-A304, and CX-NA303 are compact stereo systems that gained popularity in the 1990s for their impressive sound quality and user-friendly features. These systems reflect Aiwa's dedication to delivering superior audio experiences while remaining aesthetically pleasing, making them an excellent addition to any home environment.

The NSX-A303 and NSX-A304 models are known for their powerful dual cassette decks, allowing users to easily record and playback tapes, a feature coveted during the height of cassette popularity. These decks support high-speed dubbing, providing efficiency for users wanting to make copies of their favorite tapes. Additionally, both models come with an integrated FM/AM tuner, equipped with preset stations to ensure easy access to a variety of radio channels. Their performance is complemented by a robust equalizer that allows users to customize their sound experience, enhancing bass, midrange, and treble according to personal taste.

A significant technology utilized in these systems is Aiwa's Dynamic Bass Boost, which enhances low-frequency sounds, providing a richer listening experience, especially in music genres that thrive on deep sounds. The loudness control feature further improves audio dynamics at lower volume levels, meanly preserving a full-bodied sound even when the system isn't cranked up to full strength.

On the other hand, the CX-NA303 represents a more modern approach with a focus on CD playback and integrated digital audio capabilities. This system supports various formats, including CD-R and CD-RW, which were essential for the rise of custom music collections in the late 90s. Users appreciated its sleek design with clear LCD display panels showing track information, enhancing usability during playback.

All three models are characterized by their compact form factor, making them suitable for smaller living spaces without sacrificing sound quality. The systems often include remote control functionality, allowing users to navigate through tracks and adjust settings without needing to be right next to the unit.

Overall, the Aiwa NSX-A303, NSX-A304, and CX-NA303 are not just audio players; they represent a blend of nostalgia and technological innovation that cater to both audiophiles and casual listeners alike, ensuring quality sound in a compact design.
Top Page Image Contents