How to assemble GBF PRO RECUMBENT BIKE (1)
Follow the procedure below to assemble the product.
Brake button | 3 4 5 |
7
6
3Installing the steering unit
•Insert the steering unit in the steering post and securely tighten the “steering unit installation screw set” (4 screws).
Steering unit
2
11
Steering unit installation screw
10
9
12
1
Diagram showing com- pleted assembly
1Installing the front and rear legs
•Use the “front and rear leg installation screw set” (4 each of screws and washers) to securely install the front legs (with casters) to the front of the main unit (steering post side).
•In the same way, install the rear legs onto the rear of the main unit.
Flat washer
4Installing the controller bracket
•Remove the M5 screws (X4) from the back of the controller unit.
•Secure the controller bracket to the controller with the removed M5 screws.
M5 screw
Controller bracket
5 | Installing the steering assembly and controller |
• | Remove the M6 cap bolts which fasten the steering installation |
| bracket to the steering unit. |
• | Install the steering, and securely fasten the steering installation |
| bracket and controller using the bolts which were previously re- |
| moved. |
ENG
Flat washer
Nut
Front leg
(with casters)Front and rear leg
Nut
Rear legs
Important Install the steering so that the steering assembly is |
perpendicular to the steering unit. |
M6 cap bolt
Controller
Steering | Steering installation bracket |
|
installation screws
(level adjustment screw)
2Installing the steering post
•Attach the two connectors on the steering post to the two connec- tors on the main unit.
•Turn the steering post adjustment lever counterclockwise to loosen
it and then insert the steering post into the frame of the main unit.
Caution When inserting the steering post into the frame of the main unit, be careful not to pinch the cable inside the pipe against the post.
•Raise the steering post to the mark and then secure the post using the steering post adjustment lever.
•Align the hole of the steering post with that on the side of the frame pipe, install and tighten the stopper screw.
| Steering post |
Cable |
|
connector | Steering post |
| adjustment lever |
Stopper screw
Steering unit |
6Installing the bracket
•Install the bracket on the steering unit. Insert the bracket from underneath the steering unit and securely fasten the bracket using the supplied bolt.
Important Install the bracket so that the bracket is perpen- dicular to the steering unit.
Bracket
Flat washer
Installation bolt
3