Cateye GB-300R operation manual Adjusting the Components, GBF PRO Recumbent Bike Controller

Adjusting the Components

Before using the product, follow the procedure below and adjust the components.

•Adjusting the leg adjusters

•If the main unit is unstable on the floor, use the adjusters of the rear leg to stabilize the unit.

Rear legs

Adjustment

•Moving the seat forward/backward

•Raise the seat slide adjustment lever to slide the seat forward/ backward when sitting on the seat. With the seat at the desired position, release the lever and slightly move the seat. The position

of the seat is now fixed.

Caution When adjusting the seat position, make sure to slide the seat to the desired position with your feet on the pedals.

Slide the seat

ENG

•Raising/lowering the steering post

•Turn the steering post adjustment lever counterclockwise to move the steering post vertically.

•With the steering post at the desired height, turn the steering post adjustment lever clockwise to tighten it. The height of

the steering post is now fixed in position.

Caution Do not raise the steering post above the maximum height mark.

Steering post adjustment lever

Seat slide adjustment lever

•Adjusting the pedal Strap

•Undo the pedal belt clasp on the right and left pedals. Fasten the clasps again at holes which are near the correct size for your feet.

Caution After adjusting the pedal belts, be sure to securely fasten the clasps.

•When moving the main unit

•When moving the main unit, stand behind the unit and lift the rear leg of the unit to slightly raise the rear of the unit. The unit can now be moved on the casters.

Pedal belt

GBF PRO RECUMBENT BIKE Controller

Cautions • Certain software packages whose packaging or documentation provides no indication of analog compliance or compatibility will not work in analog mode.

•Certain software packages will not switch mode even if the analog mode switch is pressed. In the case of certain software packages, the mode switches automatically.

Important: Depending on the software, the GBF PRO RECUMBENT BIKE main unit controls sometimes take precedence over the gameplay screen and prevent operation of the controller.

Reference:	This controller can be used as a controller for “Playstation2”. In this case the sensitivity adjustment level controls will not be
	activated. Also note that it does not have the vibration function.
Steering sensitivity level control				Acceleration sensitivity level control
L2 button*				R2 button*
L1 button*				R1 button*
SELECT button				START button
				Green button*
Direction key		L	R	Pink button*
Signal from controller:		STEERING LEVEL	SPEED LEVEL	Brake signal
When analog mode is OFF.
		SELECT	START	Red button*
		ANALOG
				Blue button*
				Speed signal
Left-hand stick/L3 button				Right-hand stick/R3 button
Signal from controller:
When analog mode is ON.				Analog mode switch

*Certain software does not work well with this device due to differences in button functions. In such cases, changing the function assigned to particular buttons will allow these software packages to work. For further information on how to change these functions, see "Changing button functions".

5