How to assemble GBF PRO RECUMBENT BIKE (2)
ENG
7Installing the console
•Remove the 4 screws on the back of the console.
•Insert the cable connector which extends from the bracket into
the cable inlet on the back of the console.
Caution Insert the cable connector firmly as far as it will go. If it is not inserted properly and the contact is poor, the console will not function.
•Secure the console to the bracket with the removed screws.
•Attach the connector on the steering post to that on the bracket. Important Conceal the excess cord inside the steering post.
Console
Cable
Bracket | connecter |
Steering post
8Connecting the controller
•Insert the speed sensor cable plug (light blue) which extends from the steering post into the “S” jack on the controller.
•Install the brake button onto the steering assembly. Insert the cable plug (yellow) into the “B” jack on the controller.
Important Wind excess brake button cord around the steering assembly.
•Insert the connection cable plug into the “H” jack on the control- ler. Insert the straight plug on the other end of the cable into the jack on the bottom of the steering unit.
10Installing the seat handle
•Place the seat handle in position on the rear of the seat base and
securely tighten the “seat handle installation screw set” (2 screws).
Caution Make sure to install the seat handle with the ends of the handle pointing upward.
Installation angle
Seat handle installation screws
Nut
Flat washer
11Installing the seat cushion
•Install the two “seat cushion A installation screws” on either side of the back of the seat cushion A (seat) and temporarily tighten the two screws.
•Secure the side of the cushion on which the screws were tempo- rarily tightened to the top of the seat base.
•Install the remaining two screws and tighten all four screws to securely fasten the cushion.
Seat cushion A installation screw/flat washer
Seat cushion A
Flat washer
Brake button
Connection cable
Cable from the steering post
Brake button cable
Connection cable
Seat cushion A installation screw
•Place the seat cushion B
(backrest) in position with | Seat cushion B | |
the screw holes on the back | ||
| ||
of the seat base aligned; se- |
| |
curely tighten the “seat cush- |
| |
ion B installation screw set” |
| |
(4 screws). |
|
Steering unit
9Installing the seat base
•Remove the tapping screw from the end cap and then remove the end cap from the back end of the seat rail.
Remove the stopper from the side of the rail.
•Insert the main unit rail while raising the seat slide adjustment lever.
•Replace the stopper and end cap in their original positions.
End cap
Stopper
Seat base
Tapping screw
Seat rail
Seat slide adjustment lever
Seat cushion B installation screw
R washer
12Installing the pedals
•Use the provided special tool to securely fasten the pedals to the crank, as shown in the figure.
•Be sure to identify R and L of the pedal with the engraved mark.
•Fasten clockwise the R pedal, and counterclockwise the L pedal.
|
| Front |
Special tool | L | R |
|
|
4