NordicTrack NTL15809.1 user manual Assembly, Wrench

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, some lubricant may be transferred to the top of the walking belt or the shipping carton. This is normal and does not affect performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver		and adjustable
wrench	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. To avoid damaging parts, do not use power tools for assembly.

3/8" Jam Nut (7)–2	3/8" Star Washer	#8 x 3/4"	3/8" x 1 1/4"
	(6)–10	Tek Screw (24)–4	Patch Bolt (2)–6
3/8" x 1 3/4" Bolt (3)–1		3/8" x 2" Bolt (4)–1
	3/8" x 3 3/4" Patch Bolt (5)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, raise the front
of the treadmill and insert the crossbar on the
Base (103) into the cutout in the cardboard
stand as shown. Have the second person hold
the treadmill until assembly step 3 to prevent
it from moving forward or backward.
WARNING: Serious injury
may occur if the treadmill moves for-
ward or backward and falls off the card-
board stand. A second person must	103
hold the treadmill until assembly step 3
to prevent the treadmill from moving,	Cardboard
tipping, or falling.
	Stand
	6