NordicTrack NTL15909.3 warranty Operation and Adjustment, PRE-LUBRICATED Walking Belt

Page 13

OPERATION AND ADJUSTMENT

THE PRE-LUBRICATED WALKING BELT

Your incline trainer features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply silicone spray or other substances to the walking belt or the walking platform. Such sub- stances will cause excessive wear.

HOW TO PLUG IN THE POWER CORD

DANGER: Improper connection of the equipment-grounding conductor in- creases the risk of electric shock. Check with a qualified electrician or serviceman if you are unsure whether the product is properly grounded. Do not modify the plug—if it will not fit the outlet, have a proper outlet in- stalled by a qualified electrician.

Your incline trainer, like other electronic equipment, can be damaged by sudden voltage changes in your homeʼs power. To decrease the risk of damaging your incline trainer, always use a surge suppres- sor with your incline trainer (see drawing 1 at the right). To purchase a surge suppressor, see precau- tion 12 on page 3.

Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge sup- pressor (TVSS). The surge suppressor must have a UL suppressed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically rated for 120 volts AC and 15 amps. There must be a moni- toring light on the surge suppressor to indicate whether it is functioning properly. Failure to use a properly functioning surge suppressor could dam- age the control system of the incline trainer (see precaution 13 on page 3).

This product must be grounded. If it should malfunc- tion or break down, grounding provides a path of least resistance for electric current to reduce the risk of elec- tric shock. This productʼs power cord has an equip- ment-grounding conductor and a grounding plug. Plug the power cord into a surge suppressor, and plug the surge suppressor into an appropriate outlet

that is properly installed and grounded in accor- dance with all local codes and ordinances. IMPORTANT: The incline trainer is not compatible with GFCI-equipped outlets.

This product is for use on a nominal 120-volt circuit

(see drawing 1). A temporary adapter may be used to

connect the surge suppressor to a 2-pole receptacle if

a properly grounded outlet is not available (see draw-

ing 2).

 

 

 

1

Grounded Outlet Box

 

 

 

Surge Suppressor

 

 

 

Grounding Pin

 

Grounding Pin

2

Grounded Outlet

 

Grounding Plug

Grounded Outlet Box

 

Adapter

Surge Suppressor

 

Lug

Grounding Plug

 

Metal Screw

The temporary adapter should be used only until a properly grounded outlet (see drawing 1) can be in- stalled by a qualified electrician.

The green-colored rigid ear, lug, or the like extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box cover. The adapter must be held in place by a metal screw.

Some 2-pole receptacle outlet box covers are not grounded. Contact a qualified electrician to deter- mine if the outlet box cover is grounded before using an adapter.

14

Image 13
Contents Serial No QUESTIONS?Table of Contents Handrails while using the incline trainer Important PrecautionsUse of this product Before beginning this or any exercise proIncline trainer is intended for in-home use Serial Number Before YOU BeginDecal Assembly See the lower inset drawing. Tie the wire tie Make sure that the power cord is unpluggedUpright Wire 78. See the upper inset draw Tighten each of them. Be careful not to pinch Upright WireScrews for step Page 102 Ties Hole Wires Console Wire Ties Page HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to USE the Manual Mode Monitor your progress with the display Change the incline of the incline trainer as desiredMeasure your heart rate if desired Turn on the fan if desiredStart the workout HOW to USE a Calorie WorkoutHOW to USE a Random Workout Metric Information ModeHOW to USE the Ifit Training Mode HOW to USE the Stereo Sound SystemHOW to Move the Incline Trainer Problem The power turns off during use TroubleshootingNot compatible with GFCI-equipped outlets Top Problem The walking belt slows when walked onKey and Unplug the Power CORD. Using Unplug the Power CORD. If the walking beltProblem The console display has lines running through it Ing belt has shifted to the right, turn the bolt counExercise Intensity Exercise GuidelinesWorkout Guidelines Exercise FrequencyKey No. Qty Description Part LIST-Model No. NTL15909.3Qty R0910A Exploded Drawing B-Model No. NTL15909.3 Exploded Drawing C-Model No. NTL15909.3 Exploded Drawing D-Model No. NTL15909.3 Ordering Replacement Parts Icon Health & Fitness, Inc., 1500 S W., Logan, UT Limited WarrantyPart No R0910A