If you purchase the optional chest pulse sensor (see page 23), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screws (7) from the back of the Console Base (98).
2.While a second person holds the Console (105), connect the wire on the receiver (A) to the indi- cated wire extending from the Console. Next, hold the receiver so the small cylinder is ori- ented as shown and is facing away from the Console. Attach the receiver to the Console in the location shown with the two included Small Screws (B).
3.Make sure that no wires are pinched. See drawing 1. Reattach the Console (105) to the Console Base (98) with the Screws (7). Discard the other wires included with the receiver.
1 |
| 105 |
|
|
|
| 98 |
| 7 |
| 7 |
|
|
| |
7 | 7 | 7 | 7 |
| 7 | ||
2 |
| Wire |
|
|
|
| |
|
| A |
|
|
|
| 98 |
|
|
| 105 |
| Cylinder | B |
|
|
|
|
9