YOU’RE Finished, Support Bars | Horizon Fitness CST3.5-4.5, CST4.5

INTRODUCTION

A S S E M B LY STEP 5 - A (CST3 . 5 model)

INTRODUCTION

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

��

ASlide the HANDLEBAR SLEEVE onto the bottom of the HANDLEBAR EXTENSION.

BSlide the HANDLEBAR EXTENSION onto the CONSOLE HANDLEBAR.

DInsert BOLT (?) through bottom hole of HANDLEBAR EXTENSION into CONSOLE MAST.

ETighten all HANDLEBAR EXTENSION bolts.

FSlide HANDLEBAR SLEEVE all the way down on HANDLEBAR EXTENSION to cover BOLT (?).

GRepeat on other side.

��

ASlide PLASTIC COVER CAPS over

SUPPORT BARS.

BSlide SUPPORT BARS into side MOUNTING BRACKETS and line up with top MOUNTING BRACKETS.

CInsert 2 BOLTS (?) into the tops and 2 BOLTS (?) into the bottoms of each SUPPORT BAR.

DSlide PLASTIC COVER CAPS down to cover BOLTS (?).

IMPORTANT PRECAUTIONS

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL CONDITIONING TROUBLESHOOTING LIMITED

OPERATION GUIDELINES & MAINTENANCE WARRANTY

	A	Slide the LONG HANDLEBAR
	��	EXTENSION onto the CONSOLE
	��	HANDLEBAR.
		HANDLEBAR.
	B	Insert BOLTS (?) into LONG
		HANDLEBAR.
��	C Align the lower part of the LONG
��		HANDLEBAR with the center of the
��	��	HANDLEBAR with the center of the
��	��	CONSOLE MAST.
	��	CONSOLE MAST.
	��
	D	Insert BOLTS (?) through bottom
		holes of LONG HANDLEBAR into
	��	CONSOLE MAST.
	��
	E	Tighten all LONG HANDLEBAR
		bolts.
	F	Repeat on other side.

POWER SWITCH	and connect the cord to a power
	and connect the cord to a power
	outlet. The on/off switch is located
CIRCUIT BREAKER	next to the power cord. Flip this
	switch to the 'on' position, so that
	the switch is lit. You will hear a
	beep and the console will light up.

LIMITED TROUBLESHOOTING CONDITIONING TREADMILL WARRANTY & MAINTENANCE GUIDELINES OPERATION

CST3.5-4.5 Treadmill Rev0.2.indd 10-11

4/21/05 11:22:41 AM