Reebok 5 manual Problem The console display has lines running through it

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b. If the walking belt slips when walked on, first re-
move the key and UNPLUG THE POWER CORD.	b
Using the hex key, turn both idler roller bolts clock-
wise, 1/4 of a turn. When the walking belt is cor-
rectly tightened, you should be able to lift each
edge of the walking belt 2 to 3 in. (5 to 7 cm) off
the walking platform. Be careful to keep the walk-
ing belt centered. Then, plug in the power cord, in-
sert the key, and carefully walk on the treadmill for
a few minutes. Repeat until the walking belt is
properly tightened.
PROBLEM: The console display has lines running through it

SOLUTION: a. If lines appear in the console display, see THE INFORMATION MODE on page 23 and adjust the
contrast level of the display.
PROBLEM: The crosswalk arms squeak during use
SOLUTION: a. Note: Correcting this problem requires a small	a
amount of white marine grease, available at hard-
ware stores.		121
Turn the Resistance Knob (114) counterclockwise	114
and remove it. Next, remove the Resistance Cone		116
(116) with the Crosswalk Arm (121).
Apply a thin layer of white marine grease to the
outer surface of the Resistance Cone (116). Then,
reattach the Resistance Cone with the Crosswalk
Arm (121) and the Resistance Knob (114).

28