3.Identify the Right Upright (85), which is marked with a “Right” sticker. Hold the Right Upright near the Base (95) as shown.
See the inset drawing. Tie the wire tie in the Right Upright (85) securely around the end of the Upright Wire (87). Then, pull the other end of the wire tie until the Upright Wire is routed completely through the Right Upright.
4.Hold the Right Upright (85) against the Base
(95). Be careful not to pinch the Upright Wire (87). Insert two 3/8" x 4" Bolts (7) with two 3/8" Star Washers (11) and a 3/8" x 1 1/2" Bolt
(14)with a 3/8" Star Washer (11) into the Right Upright.
Partially tighten the 3/8" x 4" Bolts (7) until the heads of the Bolts touch the Right Upright (85); do not fully tighten the Bolts yet. Partially tighten the 3/8" x 1 1/2" Bolt (14).
3 |
| 85 |
|
|
|
| |
87 | Wire Tie |
| 87 |
| 85 |
| 95 |
|
|
| |
87 | Wire |
|
|
Tie |
|
| |
4 | 85 | 14 | 7 |
| |||
| 11 | 11 | |
|
| ||
|
|
| |
|
|
| 87 |
|
|
| 95 |
8