Tunturi owner manual Handlebar Support Tube T4 Figures 3A, Handlebar Support Tube T6 Figures 3B

HANDLEBAR SUPPORT TUBE :: T4 (FIGURES 3A AND 4)

NOTE! The fastening screws are ready-mounted, so please do not loosen them.

1.Detach the wire taped to the frame tube and connect it to the wire from the handlebar support tube.

2.Lead the connected wires carefully inside the frame cover.

3.Push the handlebar support tube into place inside the frame, so that the holes for the fastening screws are at the front of the tube. Be careful not to damage the meter wire!

4.Use the enclosed Allen key to tighten both fastening screws through the holes in the tube.

NOTE! Tighten the fastening screws by turning them counter- clockwise. And not too tight!

HANDLEBAR SUPPORT TUBE :: T6 (FIGURES 3B AND 4)

NOTE! The fastening screws are ready-mounted, so please do not loosen them.

1.Expose the wire coming from the frame tube by unwrapping the orange tape that covers it, and then connect it to the wire from the handlebar support tube.

2.Thread the wire carefully inside the frame tube.

3.Push the handlebar support tube into place inside the frame tube, so that the fastening screws are on the right side of the tube. Be careful not to damage the meter wire!

4.Use the enclosed Allen key to tighten both fastening screws through the holes in the tube.

5.Finally, place the decorative plastic cover over the joint.

NOTE! Tighten the fastening screws by turning them counter-clockwise. And not too tight!

PEDALS (FIGURE 5)

The pedals are distinguished by the markings L (left) and R (right) on their shaft. Fasten the left pedal to the left pedal-crank by turning it counter-clockwise, and the right pedal to the right pedal-crank by turning it clockwise.

4 ::