Fasten the pedal straps so that the Tunturi logo faces outward. Select strap tightness, set the appropriate strap hole on the retainer from below and pull forcibly upward. Especially when the equipment is new, the strap fastening may seem relatively tight.
T.I.E. INTERFACE
Push the T.I.E. interface module carefully into place at the top of the handlebar support tube. The loose screws hanging from the metal fastening plate on the bottom of the T.I.E. module must enter the holes at the top end of the handlebar. Make sure that the module is correctly in place and tighten the fastening screws. (Please see the illustrations in the T.I.E. manual.)
Read the T.I.E. manual carefully before you start to exercise.
POWER CORD (FIGURE 6)
Before connecting the device to a power source, make sure that local voltage matches that indicated on the type plate: the T4/T6 operates at either 230 V or 115 V (North American version). Plug the socket end of the power cord into the connector, just above the rear support in the centre of the frame, and the other end into the wall socket. Turn on the power from the switch above the connector.
NOTE!
::The device must be connected to a grounded wall socket. Do not use extension wires when connecting the device to the power source.
::Make sure the power cord does not run underneath the device.
::DANGER: Always switch off the power and uplug this appliance from the electrical outlet immediately after using.
::WARNING: To reduce the risk of burns, fire, electric shock, or
injury to persons:
1)An appliance should never be left unattended when plugged in. Unplug from outlet when not in use, and before carrying out any maintenance or repair procedures.
2)Do not operate under blanket or other combustive material. Excessive heating can occur and cause fire, electric shock, or injury to persons.
:: 5