Tunturi owner manual T70/T80, Upright Tubes, Handlebar and Console

T70/T80

UPRIGHT TUBES

Connect the wire coming out of the left upright tube. Fasten each upright tube to the lower frame with four bolts. Be careful not to damage the wire coming out of the upright tube.

NOTE! Do not remove the bolts, but slide the upright tube over the bolts, and tighten by turning the bolts

COUNTER CLOCKWISE.

Place the plugs in the holes after tightening the bolts to cover up. The plugs are self-adhesive (remove protection before applying).

HANDLEBAR AND CONSOLE

Connect the wire coming out of the left handlebar with the connector in the console and push the connected wire inside the handlebar. Push the console unit onto the handrail ends and tighten all the hex screws on the upright tubes.

Apply the 4 bolts and washers to secure the Console on the upright tubes. After lining up the console, fasten the bolts.

Connect the Sensor wires from the left handlebar and slide the wire into the tube coming from the console.

3
	T70 & T80 - OWNER’S MANUAL	ENGLISH