MAINTENANCE AND TROUBLESHOOTING
Inspect and properly tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immedi- ately.
For smooth operation of the
elliptical crosstrainer, the
incline ramp should be kept clean. Using a soft cloth and
mild detergent, clean dust and other residue
from the incline
ramp where the wheels make contact with it. Other parts of the elliptical crosstrainer can also be cleaned in this way. Keep liquids off the console. Never use abrasives or solvents.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, the Side Shields (47, 48) and the Pedal Disks
(40)must be removed. Remove the indicated Screws (72, 88) from both Side Shields and Pedal Disks. Pull the Pedal Disks out of the Side Shields. Lift the Side Shields off the elliptical crosstrainer.
Next, locate the Reed Switch (50). Turn the Flywheel
(37)until the Magnet (55) is aligned with the Reed Switch. Loosen, but do not remove, the indicated Screw (72). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Rock the Flywheel forward and back just enough that the Magnet passes the Reed Switch repeatedly. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shields and the pedal disks.
50 |
37 |
55 |
72 |
HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER
47 |
48 |
40 |
88 |
72 |
If the elliptical crosstrainer rocks slightly during use, turn one or both of the leveling feet under the rear stabilizer until the rocking motion is elim- inated.
Leveling |
Feet |
20