7.While a second person holds the Console (60) near the Upright (6), connect the console wire to the Upper Wire Harness (97). Then, connect the console pulse wire to the Hand Pulse Wire (65). Insert the excess wire downward into the Upright.
Tip: Avoid pinching the wires during this step. Attach the Console (60) to the Upright (6) with four #8 x 3/4" Screws (78).
8.Identify the Right Handlebar (31), which is marked with a “Right” sticker and orient it as shown. Attach the Right Handlebar to the right Upper Body Arm (12) with two 5/16" x 1.5" Button Bolts (73) and two 5/16" Nylon Locknuts
(106).Make sure that the Nylon Locknuts are in the hexagonal holes.
Repeat this step to attach the Left Handlebar
(7)to the left Upper Body Arm (12).
7
Avoid pinching the
60wires during this step
Pulse Wire
65
6
78
Console Wire 97
8
7 | 31 |
|
106
73 Hexagonal
12
Holes
9.Plug the Power Cord (55) into the power socket at the rear of the elliptical exerciser (see HOW TO PLUG IN THE POWER CORD on page 10).
IMPORTANT: If the elliptical exerciser has been exposed to cold temperatures, allow it to warm to room temperature before plug- ging in the power cord. If you do not do this, the console displays or other electronic components may become damaged.
The ramp will calibrate automatically when the elliptical exerciser is plugged in for the first time.
12
9
55
10.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
9