Maintenance and Troubleshooting

Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.

To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. IMPORTANT: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.

CONSOLE TROUBLESHOOTING

If the console does not turn on, make sure that the power cord is fully plugged in. If the console does not display your heart rate when you hold the handgrip pulse sensor, or if the displayed heart rate appears to be too high or too low, see step 5 on page 14.

HOW TO CALIBRATE THE RAMP

If the ramp is not functioning properly, the ramp may need to be calibrated. To calibrate the ramp, hold down the Start button and the Resistance increase button for about 5 seconds until the display on the console changes. Next, press the Start button once, and then press the Ramp increase button. The ramp will move upward and downward as it calibrates. Then, two dashes and the word RAMP will appear in the display. The ramp is now calibrated.

HOW TO ADJUST THE BELT

If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the belt may need to be adjusted.

	To adjust the belt,
	first carefully pry
	off the right Disc
	Cover (41) using
	a flat screwdriver.
	Next, remove the
	four screws (not	41
	shown) from the	41
	shown) from the
	center of the right	40
	Pedal Disc (40).	40
	Pedal Disc (40).
	Gently rotate the

Disc away from

the elliptical exerciser.

	Loosen, but do
	not remove, the
	three indicated
	screws (A). Insert	57
	the shaft of a	57
	the shaft of a
	screwdriver	B
	downward	C
	between the	A
	Idler (B) and the	A
	Idler (B) and the
	Idler Pulley (C).
	Pull the top of the
	screwdriver
	toward the front
	of the elliptical exerciser until the Belt (57) is tight.
	Then, tighten the three screws.

Reattach the right disc with the four screws and then reattach the right disc cover.