ParaBody 400101 manual Detail

DETAIL 9	PUSH/PULL
	CABLE
8
		13
	1/4” NUTS
	DO NOT OVERTIGHTEN!
13	SPRING PIN
FIGURE 9	ASSEMBLY	DETAIL 9
STEP 9

Assemble the PUSH/PULL CABLE from the PRESS ARM (8) to the SPRING PIN HOUSING and to the L-BRACKET on the RECEIVING TUBE (13) as shown on FIGURE 9 and DETAIL 9 using the following steps:

· Thread the first 1/4-28 IN. NUT to the bottom of the threaded end of the CABLE. Allow the other 1/4-28 IN. NUT to hang loose
on the exposed CABLE until the SPRING PIN ASSEMBLY is attached.
· Securely assemble the SPRING PIN ASSEMBLY to the
SPRING PIN BARREL. (!!! IMPORTANT !!! TIGHTEN
THE NUT OF THE SPRING PIN ASSEMBLY SE-					8
CURELY)
· Swing the PRESS ARM (8) up until the SPRING PIN of the				75	65
PUSH/PULL CABLE	engages in one of	the adjustment
holes.
· Thread the second 1/4-28 IN. NUT onto the threaded end of
the CABLE, and cinch the two 1/4-28 IN. NUTS around the
flat.
· Use the extra thread on the end of the CABLE to adjust out
slack. ( !!! DO NOT ADJUST OUT TO FAR !!! AL-
WAYS ALLOW SPRING PIN ASSEMBLY TO FULLY
ENGAGE)					9
STEP 10				76	65
• Securely tighten two 5/32” SET SCREWS (65) and insert
two 3 X 2” END CAPS (75) into the open ends of PRESS
ARM (8) as shown in FIGURE 10.
• Securely tighten two 5/32" SET SCREWS (65) and insert							48
two 2” SQ. END CAPS (76) into the open ends of PRESS
						77	6
ARM LEVER (9) as shown in FIGURE 10.				51
• Securely tighten one 3/8 X 1” BOLT (35), one 3/8” WASHER			3/8 X 1” 35
(51), and one 3/8” LOCKNUT (48) to the bottom of AD-
JUSTMENT SLIDE (6) as shown in FIGURE 10.
• Insert one 1-3/4” SQ. END CAP (77) into the end of AD-			FIGURE 10
JUSTMENT SLIDE (6) as shown in FIGURE 10.
1/2	1/2	1/2	1/2	4	1/2		1/2
0	1	2	3		5		6
			9