ParaBody 400101 manual 37 3/8 X

	37 3/8 X 2”
	51	58	79
	21
	51
FIGURE 18	48

STEP 18

•Loosely assemble two 3-1/2” PULLEYS (79) and two 2-3/8” CABLE RETAINING CLIPS (58) to the CENTER PULLEY BRACKET (21) using two 3/8 X 2” BOLTS (37), four 3/8” WASHERS (51), and two 3/8” LOCKNUTS (48). See FIGURE 18.

(NOTE: This connection will be tightened after the cable has been routed.)

	87
	17
49	52
	52
	21
	45 1/2 X 4-1/2”
	11
FIGURE 19

STEP 19

•Securely assemble the BEARING HOUSING (17) and the CENTER PULLEY BRACKEY (21) to the FRONT UPRIGHT (11) as shown in FIGURE 19, using two 1/2 X 4-1/2” BOLTS (45), four 1/2” WASHERS (52), and two 1/2” LOCKNUTS (49). (NOTE:

The conntector plates on the BEARING HOUSING (17) and the CENTER PULLEY BRACKET (21) have slotted holes. Shift the BEARING HOUSING (17) down as far as possible and the CENTER PULLEY BRACKET (21) up as far as possible before tightening.)

•Attach two 1” X 1” GLIDES (87) to plate on the BEARING HOUSING (17) as shown.

14