Horizon Fitness EX-55, EX-75, EX-65 manual Only

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

ELLIPTICAL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

10

A S S E M B LY STEP 3 (EX - 65 & EX - 75	ONLY)
SCREWS (F)
FRONT STABILIZER COVER
EX-65 ONLY
PERIMETER BARS
	SCREWS (F)
SCREWS (F)
		FRONT STABILIZER COVER
	BOLTS (E)	BOLTS (G)
REAR STABILIZER COVER
		EX-75 ONLY

NOTE: EX-55 SKIP THIS STEP

A)Open HARDWARE BAG FOR STEP 3.

B)EX-75 ONLY: Attach the PERIMETER BARS using 2 BOLTS (G) and 2 BOLTS (E).

C)EX-75 ONLY: Attach REAR STABILIZER COVER using 2 SCREWS (F).

D)Attach FRONT STABILIZER COVERS using 2 SCREWS (F) for each side.

EX-75 ONLY HARDWARE BAG FOR STEP 3 CONTENTS :

BOLT (G)	BOLT (E)	SCREW (F)
50 mm	40 mm	10 mm
Qty: 2	Qty: 2	Qty: 6

EX-65 ONLY HARDWARE BAG FOR STEP 3 CONTENTS :

SCREW (F) 10 mm Qty: 4

A S S E M B LY STEP 4
		611&3 )"/%-&#"3
	/05$)
		13&"55"$)&%
$0/40-& ."45	5"#	4&5 4$3&84
		13&"55"$)&%
		#0-5  8"4)&3
	-08&3 )"/%-&#"3

NOTE: There is NO hardware bag for this step. All hardware is pre-installed.

A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.

B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by re-inserting PRE-ATTACHED BOLT & WASHERS.

C)Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using PRE-ATTACHED SET SCREWS.

After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.

11

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

HZ_Ellipticals_Rev.1.5.indd 10-11 8/15/06 2:35:46 PM