19.Wrap the ball end of the Low Cable (8) around a Pulley (5). Attach the Pulley to the bracket on the Base Crossbar (20) with an M10 x 45mm Bolt (40) and an M10 Nylon Locknut (11). Do not overtighten the Nylon Locknut; the Pulley must be able to turn freely. Be sure the ball is on the indicated side of the bracket.
20.Route the Low Cable (8) around a Pulley (5) as shown. Attach the Pulley and a Cable Trap (21) to the lowest set of holes in the two Pulley Plates
(19)using an M10 x 45mm Bolt (40) and an M10 Nylon Locknut (11). Make sure the Cable Trap holds the Low Cable in the groove of the Pulley.
Do not overtighten the Nylon Locknut; the Pulley must be able to turn freely.
21.Attach the end of the Low Cable (8) to the bracket on the Rear Base (3) using an M10 x 20mm Bolt
(26)and an M10 Nylon Locknut (11).
22.Press a 50mm x 70mm Outer Cap (65) onto each end of the Stabilizer (66).
Attach the Stabilizer (66) to the Bench Frame (61) with two M10 x 60mm Button Head Bolts (92) and two M10 Nylon Locknuts (11). Note: Do not tighten the Nylon Locknuts yet. There is an indentation around each hole on one side of the Stabilizer; this side must be facing the floor.
19 |
|
|
|
|
| 8 |
|
| Ball |
| 5 |
|
|
| |
|
| 11 | Bracket |
|
|
| |
20 |
|
| 40 |
20 |
|
|
|
|
|
| 19 |
| 11 |
| 40 |
|
|
| |
| 5 |
| 21 |
|
|
| |
| 8 |
|
|
21 |
|
|
|
| 8 |
|
|
| Bracket |
|
|
|
|
| 3 |
|
|
| 11 |
|
|
| 26 |
22 |
|
| 11 |
|
|
| |
61 | 65 |
| 66 |
|
| 92 | 65 |
|
|
|
11