7.Press a 38mm Bushing (29) into each side of the Left Weight Glider (32). Slide the Left Weight Glider onto the indicated end of the Barbell (35) and secure it to the Barbell using an M8 x 20mm Screw (50). Do not tighten the Screw yet. Make sure the Left Weight Glider is oriented exactly as shown.
8.Press a 50mm Bushing (47) into the indicated end of a Weight Adapter (33). Slide the Weight Adapter onto the Barbell (35) and secure it to the Barbell using a Large Washer (44) and an M10 x 25mm Bolt (43).
Attach the other Weight Adapter (33) to the other end of the Barbell (35) in the same manner.
Tighten the M8 x 20mm Screws (50) used in steps 6 and 7.
9.Note: This step requires the help of a second person.
Slide the Right Safety Spotter (23) and the Left Safety Spotter (24) onto the Weight Guides (18).
Make sure the Safety Spotters are oriented exactly as shown.
Slide the assembled Locking Bar (34) and the Right and Left Weight Gliders (31, 32) onto the Weight Guides (18). Make sure the Locking Bar and Weight Gliders are oriented exactly as shown.
10.Press a 60mm Square Inner Cap (55) into each end of the Top Crossbar (9). Attach the Top Crossbar to the Uprights (1) using four Joint Plates (12), eight M10 x 80mm Bolts (41), and eight M10 Nylon Locknuts (11). Do not tighten the Nylon Locknuts yet.
Secure the Top Crossbar (9) to the Weight Guides (18) using two M10 x 30mm Bolts (38) and two M10 Small Washers (6).
7 |
|
|
|
| 35 |
|
|
| 29 | 32 | 50 |
|
| ||
|
|
| 29 |
8 |
|
|
|
| 35 |
|
|
| 33 |
|
|
|
| 47 | 44 |
|
|
| |
|
|
| 43 |
9 |
|
|
|
31 | 34 |
|
|
|
|
| |
23 |
|
|
|
| 32 |
|
|
18 | 24 |
|
|
| 18 |
|
|
10 | 38 |
|
|
55 |
|
| |
|
|
| |
| 6 |
|
|
| 9 | 38 |
|
|
|
| |
|
| 6 |
|
| 11 |
| 55 |
| 12 |
| 11 |
|
|
| |
| 12 |
|
|
41 |
|
|
|
18 | 41 |
|
|
| 1 |
| 1 |
| 18 |
| |
|
|
|
8