31.Attach the Adjustable Bench Leg (60) to the Bench Leg (59) with the Adjustment Knob (85).
Insert a 45mm Square Inner Cap (88) into the top of the Adjustable Bench Leg (60).
32.Insert three 45mm Square Inner Caps (88) into the ends of the Leg Lever (70). Insert a 25mm Round Inner Cap (87) into the weight tube on the Leg Lever. Press a 25mm Angled Outer Cap (86) onto the other end of the weight tube.
Attach the Leg Lever (70) to the Adjustable Bench Leg (60) with an M10 x 70mm Bolt (91) and an M10 Nylon Locknut (11). Note: Do not overtight- en the M10 Nylon Locknut; the Leg Lever must pivot easily.
33.Insert two 19mm Round Inner Caps (77) into the ends of the three Pad Tubes (69).
Insert two Pad Tubes (69) through the holes in the Leg Lever (70). Slide a Foam Pad (76) onto each side of the Pad Tubes.
Insert a Pad Tube (69) through the upper tube on the Adjustable Bench Leg (60). Slide a Foam Pad (76) onto each side of the Pad Tube.
34.Attach the Curl Pad (63) to the Curl Upright (64) with two M6 x 16mm Screws (89).
35.Make sure all parts are properly tightened before you use the weight bench. The use of the remaining parts will be explained in ADJUSTMENTS on pages
31 | 88 |
|
|
|
|
| |
|
| 60 |
|
| 85 |
|
|
| 59 |
|
|
32 |
|
|
|
|
| 91 |
|
| 88 | 60 |
|
|
|
| |
|
| 88 | 11 |
| Weight |
| |
|
|
| |
| Tube |
|
|
| 87 | 86 |
|
| 70 |
| |
| 88 |
| |
|
|
| |
33 | 77 |
|
|
|
|
| |
| 76 | 60 |
|
76 |
|
| |
|
| 69 |
|
| 77 |
|
|
| 76 |
| 76 |
|
|
| |
| 70 |
|
|
|
| 76 | 77 |
34 |
|
|
|
|
| 63 |
|
|
|
| 89 |
|
| 64 |
|
14