23.Press a 50mm Square Outer Cap (73) onto each end of the Bench Base (62).
Attach the Bench Base Joint Plate (72) to the Bench Base (62) with two M10 x 70mm Bolts (91), two M10 Large Washers (58), and two M10 Nylon Locknuts (11).
Attach the Bench Leg (59) to the Bench Base Joint Plate (72) with two M10 x 70mm Bolts (91), two M10 Large Washers (58), and two M10 Nylon Locknuts (11). Be sure the welded nut is in the position shown.
Do not tighten the M10 Nylon Locknuts (11) yet.
24.Attach the Bench Leg (59) to the Bench Frame
(61)with two Thick Joint Plates (71), four M10 x 70mm Bolts (91), and four M10 Nylon Locknuts
Note: Tighten all the M10 Nylon Locknuts (11) used in steps
25.Press two 25mm x 40mm Inner Caps (79) into each Backrest Tube (78). Press two 25mm x 40mm Inner Caps into the Backrest Adjustment Bracket (83).
Lubricate an M10 x 190mm Bolt (75). Attach the Backrest Tubes (78) to the welded tube on the Backrest Adjustment Bracket (83) with the Bolt, two M10 Large Washers (58), and an M10 Nylon Locknut (11). Make sure that the Backrest
Tubes are turned as shown. The indicated holes are not centered in the Backrest Tubes. Turn the Backrest Tubes so the holes are clos- er to the floor. Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily.
26.Lubricate an M10 x 190mm Bolt (75). Attach the Backrest Tubes (78) to the welded tube on the Bench Frame (61) with the Bolt, two M10 Large Washers (58), and an M10 Nylon Locknut (11).
Note: Do not overtighten the Nylon Locknut; the Backrest Tubes must pivot easily.
23 |
|
| Welded Nut |
|
|
| |
|
| 58 | 59 |
|
|
| |
| 91 |
| 11 |
| 62 | 58 | |
|
|
| |
73 | 58 |
| 72 |
| 91 | 58 |
|
|
|
| |
|
| 73 |
|
24 |
|
|
|
91 |
| 71 |
|
|
|
| |
|
|
| 61 |
|
|
| 71 |
|
| 59 | 11 |
|
|
| |
25 | Lubricate | 78 | 79 |
75 |
| 58 |
|
|
|
| |
Holes |
|
| |
|
|
| 11 |
|
| 58 | |
79 |
|
| 83 |
|
|
| |
| Welded |
| 79 |
| Tube |
| |
|
|
| |
26 | Lubricate |
| |
|
| ||
| 58 |
|
|
75 |
|
|
|
| 78 |
| 58 |
|
|
| |
Welded Tube | 11 |
| |
| 61 |
|
|
12