Gold's Gym GGSY3066.1 manual Using the Curl PAD, Pad to use the press arms, Adjusting the Backrest

Page 26

USING THE CURL PAD

To use the Curl Pad (33), remove the indicated 50mm Round Inner Cap (39) and insert the Curl Post (11) into the Front Leg (10). Tighten the Curl Adjustment Knob (58) into the Front Leg. Make sure that the Adjustment Knob passes through a hole in the Curl Post.

When you are performing exercises that do not require the Curl Pad, remove the Curl Pad (33) and reinsert the 50mm Round Inner Cap (39) into the Front Leg (10). Note: You must remove the Curl

Pad to use the press arms.

ADJUSTING THE BACKREST

The Backrest (31) can be adjusted to provide the cor- rect position for each exercise. To adjust the Backrest, loosen but do not remove the Backrest Adjustment Knob (53) and pull it out. Move the Backrest in or out of the Upright (2). Insert the Adjustment Knob into the Upright and through the Backrest Frame (not shown). Tighten the Adjustment Knob.

The Seat (32) can be adjusted in the same manner.

LOCKING THE WEIGHT STACK

To lock the weight stack, insert the Locking Pin (72) through one of the holes in the Guide Rods (18) and secure the Pin with the Lock (73).

33

 

11

 

39

58

 

 

10

 

2

31

53

32

 

 

18

 

72

 

73

26

Image 26
Contents Call TOLL-FREE QUESTIONS?Model No. GGSY3066.1 Serial No Table of Contents Important Precautions Left Side Before YOU BeginRight Side Part Identification Chart 89.5mm SpacerPage Page Four Stages of the Assembly Process AssemblyMake Assembly Easier Nylon Locknuts yet Do not tighten the Nylon Locknuts yetNylon Locknut yet Nylon Locknuts 78. Do not tighten the Nylon Locknuts yetWeight Tube is oriented as shown Repeat this step for the Right Shroud not shownRepeat this step for the Right Shroud Arm Assembly Repeat this step for the Left Butterfly Arm Repeat this step for the Left Press Arm not shown Tighten the Nylon Locknuts used in step BendCable Assembly Grease Flat Edge Page Page Lever Cable 51 is under the Pulley Page 113 Repeat this step for the Left Butterfly Pad Knob passes through one of the holes in the Backrest FramePage Page Attaching the Accessories AdjustmentChanging the Weight Setting Seat 32 can be adjusted in the same manner Using the Curl PADAdjusting the Backrest Locking the Weight StackLocking the LEG Lever Weight Resistance ChartWeight High Butterfly Press ARM LEG Lever LOW Pulley LbsLeg Lever Cable Cable DiagramButterfly Cable Maintenance Tightening the CablesExercise Guidelines Cooling Down Staying MotivatedPart LIST-Model No. GGSY3066.1 Qty Description7mm Spacer Grease Packet 112 M12 Nut Exploded Drawing A-Model No. GGSY3066.1 R0907A Exploded Drawing B-Model No. GGSY3066.1 R0907A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty