Healthrider HREL69011 manual Lower Wire Harness, Do not pinch the Wire Harnesses, This step

1.Identify the Front Stabilizer (3), which has Wheels (32) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame

with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29). Make sure that the Front

Stabilizer is turned so the Wheels are not touching the floor.

2.While another person lifts the back of the Frame (1), attach the Rear Stabilizer (4) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).

3.While another person holds the Upright (2) in the posi- tion shown, connect the Upper Wire Harness (86) to

the Lower Wire Harness (87).				Carefully pull the
upper end of the Upper Wire Harness			to remove
any slack. While holding the upper			end of the
Upper	Wire Harness,	insert the Upright into the
Frame	(1). Do not pinch the Wire Harnesses.

Next, turn the Upright Knob (91) counterclockwise sev- eral turns. Pull the Knob, slide the Upright (2) down until the Knob is aligned with one of the four adjust- ment holes, and then release the Knob. Do not tighten

the Knob yet.

4. Connect the wire harness on the Handgrip Pulse Sensor (81) to the indicated wire harness on the Console (5). Insert both wire harnesses into the open- ing in the bottom of the Console.

Refer to the inset drawing. Insert the metal tube on the Handgrip Pulse Sensor (81) into the metal bracket

inside the Console (5) as shown.	Be careful not to
pinch the wire harnesses.	Align the holes in the metal

tube with the holes in the metal bracket, and tighten two M4 x 16mm Screws (66) into the indicated holes.

Snap the bookrack onto the Console (5) where shown.

1	32
	34
	32
	3
	1
	29
2
	29	4
	29
	1	34
3
	Make sure the
	Wire Harnesses
	(86, 87) do not
	get pinched	and
	damaged during
	this step.
	2
	86
	87
		1
		91
4		5	81
	Bookrack
	66
	5
	Bracket
	Tube	66
	81
	Wire Harnesses

6