Pole Sections

3. While maintaining alignment, bounce assembly and lower section (P-3) together as shown until they no longer move toward taped reference mark.

NOTE:

SHOULD HAVE A

3-1/2" (9 CM)

MINIMUM OVERLAP.

CAUTION!

THE IDENTIFICATION STICKER IS LOCATED 5" FROM THE END OF THE POLE. WHEN PROPERLY POUNDED TOGETHER, THE POLE SECTIONS SHOULD HAVE A 3-1/2"

MINIMUM OVERLAP, LEAVING 1- 1/2" BETWEEN THE OVERLAPPING POLE AND THE IDENTIFICATION STICKER.

IMPORTANT!

Align dimple of middle pole section (P-2) into trough of bottom pole section (P-3) as shown.

P-2

IMPORTANT!

Holes in top pole (P-1) and bottom pole (P-3) sections MUST align to correctly position elevator system toward playing surface.

P-1

RODS SHOWN ARE

FOR VISUAL

REPRESENTATION

OF ALIGNMENT

AND ARE NOT

SUPPLIED WITH

THE HARDWARE

P-2

TROUGH

1-1/2"

Bottom pole

STICKER

DIMPLE

HOLE

P-3

WOOD SCRAP

(NOT SUPPLIED)

11	03/05	P/N 211014