Spalding 211014 manual Face of Backboard

Page 21

2. Remove packaging materials from handle assemblies (P-10 and P-11).

P-11

Remove screws on both sides of tube.

P-10

3. Slide upper tube (P11) onto handle assembly (P-10). Reinsert screws removed in previous step as shown.

P-11

P-10

Screws removed in step 2

NOTE:

Rotate upper tube to line up screw holes. Reinsert screws removed in previous step as shown.

4. Assemble brackets (P-21) to backboard using bolts (H-25) metal spacers (H-24) and nuts (H-26) as shown. The spacers may fit very tightly between the brackets and may need to be tapped gently into place with a hammer.

 

 

H-24

 

 

P-21

 

 

P-21

 

 

 

 

 

H-25 H-26

Face of Backboard

P-21

H-24

H-26

H-24

H-26

H-25

H-25

21

03/05

P/N 211014

 

 

 

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Universal Elevator Mount Before YOU Start Safety Instructions Front View Parts Identifier Item P-27 Hardware List see Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers & Caps 13 cm Pole Sections Section B Assemble the Base 03/05 Should be facing Orientation of Struts Do not Over Flange nuts H-11 Carefully reposition Section C Assemble the Elevator System & Backboard Completed Assembly Face of Backboard Position springs P-12 against elevator tubes as shown Install Slam Jam Rim to Backboard 03/05 03/05 TOP View Clip ARM Install net P-33 Insert net into bottom of clip as shown Section D Install Front Cover & Handle Height Adjustment
Top Page Image Contents