Spalding 211014 manual Safety Instructions

Page 3

SAFETY INSTRUCTIONS

FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR

PROPERTY DAMAGE AND WILL VOID WARRANTY.

Owner must ensure that all players know and follow these rules for safe operation of the system.

To ensure safety, do not attempt to assemble this system without following the instructions carefully. Proper and complete assembly, use, and supervision are essential for proper operation and to reduce the risk of accident or injury. A high probability of serious injury exists if this system is not installed, maintained, and operated properly.

If using a ladder during assembly, use extreme caution.

Check base regularly for leakage. Slow leaks could cause the system to tip over unexpectedly

Seat the pole sections properly (if applicable). Failure to do so could allow the pole sections to separate during play and/or during transport of the system.

Climate, corrosion or misuse could result in system failure.

If technical assistance is required, contact Huffy Sports.

Minimum operational height is 6'-6" (1.98m) to the bottom of backboard.

Most injuries are caused by misuse and/or not following instructions.

Use caution when using this unit.

NOTICE TO ASSEMBLERS

ALL Huffy Sports basketball systems, including those used for DISPLAYS, MUST be assembled and ballasted with sand or water according to instructions. Failure to follow instructions could result in SERIOUS INJURY. It is NOT acceptable to devise a makeshift weight system.

IMPORTANT!

Remove all contents from boxes.

Be sure to check inside pole sections; hardware and additional parts are packed inside.

 

WARRANTY CARD:

 

 

Please remember to complete your product

 

registration form either on-line at:

 

 

www.huffysports.com/warrantycard or mail-in

 

the enclosed postcard.

 

3

03/05

P/N 211014

Image 3
Contents Universal Elevator Mount Before YOU Start Safety Instructions Front View Parts Identifier Item P-27 Hardware List see Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers & Caps 13 cm Pole Sections Section B Assemble the Base 03/05 Should be facing Orientation of Struts Do not Over Flange nuts H-11 Carefully reposition Section C Assemble the Elevator System & Backboard Completed Assembly Face of Backboard Position springs P-12 against elevator tubes as shown Install Slam Jam Rim to Backboard 03/05 03/05 TOP View Clip ARM Install net P-33 Insert net into bottom of clip as shown Section D Install Front Cover & Handle Height Adjustment