Spalding 211014 manual Clip ARM

Page 27

12. Install net clips (H-28).

CLIP “ARM”

WARNING!

USE OF THIS PRODUCT WITHOUT PROPER INSTALLATION OF SMART CLIPS®, OR WHEN ALL SMART CLIPS® ARE NOT PRESENT COULD RESULT IN BODILY HARM. BE SURE TO FOLLOW DIRECTIONS CAREFULLY.

H-28

CLIP “BODY”

H-28

A

Insert one “arm” of clip into ram as shown. Twist “body” of clip slightly so that second “arm” slides over the top of the first “arm” as shown.

Push in direction indicated by arrows.

Push second “arm” back and into ram as shown.

B

Twist “body” of clip slightly again to spread “arms” of clip.

Clip “arms” must be flat and touching edge-to-edge as shown, without overlapping.

C

27

03/05

P/N 211014

 

 

 

Image 27
Contents Universal Elevator Mount Before YOU Start Safety Instructions Front View Parts Identifier Item P-27 Hardware List see Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers & Caps 13 cm Pole Sections Section B Assemble the Base 03/05 Should be facing Orientation of Struts Do not Over Flange nuts H-11 Carefully reposition Section C Assemble the Elevator System & Backboard Completed Assembly Face of Backboard Position springs P-12 against elevator tubes as shown Install Slam Jam Rim to Backboard 03/05 03/05 TOP View Clip ARM Install net P-33 Insert net into bottom of clip as shown Section D Install Front Cover & Handle Height Adjustment