Spalding 211014 manual Completed Assembly

Page 20

1. While the system is securely resting on the sawhorse.

Install triangle plates (P-17) and elevator tubes (P-19 and P-20) to top pole section (P-1) as shown. Install pole cap (P-18) at this time.

WARNING!

WARNING!

TWO PEOPLE REQUIRED FOR THIS PROCEDURE. FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE.

H-15

H-15

TIGHTEN BOLT (H-18) IN LOCK NUT (H-15) UNTIL FLUSH (EVEN) WITH LOCK NUT’S OUTER EDGE.

H-17

P-17

P-1

P-20

P-19

H-15

P-18

COMPLETED ASSEMBLY

 

P-17

 

 

H-17

H-19

 

 

 

H-17

 

 

 

P-20

 

 

H-18

P-19

 

 

 

H-18

P/N 211014

03/05

20

 

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Universal Elevator Mount Before YOU Start Safety Instructions Front View Parts Identifier Item P-27 Hardware List see Hardware Identifier Hardware Identifier Bolts & Screws Hardware Identifier Plastic Spacers & Caps 13 cm Pole Sections Section B Assemble the Base 03/05 Should be facing Orientation of Struts Do not Over Flange nuts H-11 Carefully reposition Section C Assemble the Elevator System & Backboard Completed Assembly Face of Backboard Position springs P-12 against elevator tubes as shown Install Slam Jam Rim to Backboard 03/05 03/05 TOP View Clip ARM Install net P-33 Insert net into bottom of clip as shown Section D Install Front Cover & Handle Height Adjustment
Top Page Image Contents