Spalding 21196804 manual Before YOU Start

Page 2

BEFORE YOU START!

To ensure optimal playability of backboard system, a close tolerance fit between the elevator components and hardware is required. Test-fit large bolts into large holes of elevator tubes, backboard brackets, and triangle plates. Carefully rock them in a circular motion to ream out any excess paint from holes if necessary.

Not all items pictured are included with every model.

35

HEIGHT ADJUSTMENT

TO ADJUST BACKBOARD:

1

1.

While holding handle, remove pin.

3

 

2.

Move elevator up or down to

 

 

desired height.

2

3. Replace pin full length to lock system at desired height.

2

201251 2/99

P/N 21196804 10/04

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Inground System Before YOU Start Parts List See Hardware Identifier Safety Instructions Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole TOP Middle FIG. a Side View Keep Ground Sleeve CAP on Bottom Pole Label should be Front Side Tighten just until washers 10 stop moving Side Section B Assemble the Elevator Tubes to Backboard 10/04 As shown Container to Mix Phillips-Head Screwdriver 4 Wrenches 21196804 10/04 Install Slam Jam Rim to Backboard USE EYE Protection Reinforcement Bar 21196804 10/04 Install clips NET Installation None Playing Surface 10 ft 05 m
Top Page Image Contents