Spalding 21196804 manual Keep Ground Sleeve CAP on Bottom Pole

Page 11

8. After concrete has cured, remove bottom pole section from ground sleeve (4). Place anti-skid tape (36) around the bottom area of bottom pole (see note A).

KEEP GROUND SLEEVE CAP ON BOTTOM POLE.

36

5

4

NOTE A:

Place top edge of anti-skid

tape on mark made in

step 7.

NOTE B:

Tape prevents the pole from rotating during play.

11

10/04

P/N 21196804

Image 11
Contents Inground System Before YOU Start Parts List See Hardware Identifier Safety Instructions Hardware Identifier Bolts & Screws #22 Section a Assemble the Pole TOP Middle FIG. a Side View Keep Ground Sleeve CAP on Bottom Pole Label should be Front Side Tighten just until washers 10 stop moving Side Section B Assemble the Elevator Tubes to Backboard 10/04 As shown Container to Mix Phillips-Head Screwdriver 4 Wrenches 21196804 10/04 Install Slam Jam Rim to Backboard USE EYE Protection Reinforcement Bar 21196804 10/04 Install clips NET Installation None Playing Surface 10 ft 05 m