Nike HRM/SDM Specifications, FCC and RSS-210 Compliance, Technical Support and Product Questions

Page 27

Specifications

IP code: IPX8

Applied Part: Type CF

Storage: Standard Conditions (within operating temperature)

Watch

Water-Resistant up to 50 Meters:

Designed for underwater performance to a depth of 165 feet (50 m).

ATTENTION: Water damage may occur if watch buttons are pressed while underwater.

Operating Temperature: -5˚ to 50˚ Celsius

Material Specifications:

Battery Door: Stainless Steel

Bezel: Stainless Steel

Buckle: Stainless Steel

Case: Polycarbonate

Caseback: Polycarbonate

Crystal: Mineral Glass

Strap: Urethane

Mode Limits:

Chronograph: 99:59’59”

Heart Rate: 30 - 240 bpm

HRM Transmitter

Water-Resistant up to 30 Meters:

Wipe dry after use. Do not use around conductive material.

Operating Temperature: -5˚ to 50˚ Celsius

Accuracy: +-1% or +-1% bpm (steady state)

Material Specifications:

Case: Polycarbonate

Strap: Urethane

Band: Elastic

SDM Pod

Water-Resistant up to 10 Meters:

Wipe dry after use. Not intended for underwater use.

Operating Temperature: 0˚ to 40˚ Celsius

Accuracy: +-3% (most runners)

Material Specifications:

Case: ABS

Strap: Urethane

Clip: Nylon

FCC and RSS-210 Compliance

This device complies with part 15 of the FCC and RSS-210 of the IC rules.

Operation is subject to the following two conditions:

(1)This device may not cause harmful interference.

(2)This device must accept any interference that may cause undesired operation of the device.

Tested to comply with FCC standards.

For home or office use.

FCC WARNING: Changes or modifications not expressly approved by Nike could void your authority to operate this device under FCC regulations.

Technical Support and Product Questions

www.nike.com/timing

NIKE CONSUMER AFFAIRS: 1-888-350-6453

27

Image 27
Contents Contents Triax Elite features HRM/SDM training system Minimum System Requirements Triax Elite IntroductionVery Important Very Important Setup of the Triax Elite Training SystemSetup Positioning the HRM Transmitter and SDM Pod for Use USB Dock Installation Installing Application, USB Dock and DriversLink the Watch to the Computer Features of the Application Using SET Watch Feature Schedule and Upload Workouts Page Exit Set TimeSet Alarm Select Workouts and Review Segments To the application Begin a WorkoutCalib Push Start Auto-Calibrate the SDM PodManually Calibrate the SDM Pod Total Using the ChronographSave Run Data Reset Chronograph Adjustable element Set the Auto-Lap FeatureTo view detailed Stats on most Recent run Review Saved Runs or WorkoutsLight Intensity Heart-Rate Intensity Chart10 mi Running Pace Chart Linking Digital Components to the Watch Watch does not link with the USB dock TroubleshootingHRM transmitter does not link with the watch Specifications FCC and RSS-210 ComplianceTechnical Support and Product Questions