INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
UPPER HANDLEBAR
WATER BOTTLE HOLDER
REMOTE RESISTANCE TOGGLES
SEAT BACK 
SEAT FRAME 
LOWER HANDLEBAR 
SEAT BASE 
SEAT GUIDE RAIL
SEAT GUIDE RAIL CAP 
BASE FRAME 
CONSOLE
CONSOLE MAST
MAST BOOT
MAIN FRAME
FRONT STABILIZER TUBE
FRONT END CAP |
PEDALS |
A S S E M B LY STEP 1
BASE FRAME 
REAR STABILIZER TUBE 
REAR END CAPS
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (C)
LEVELER ADJUSTER 
LEVELER 
FRONT STABILIZER TUBE
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
YOU
REAR END CAP 
SEAT ADJUSTMENT LEVER
BEGIN
BEFORE BEGIN
REAR STABILIZER TUBE 
MAIN FRAME 
BOLT (A)
SPRING WASHER (B) 
WASHER (C) 
BEFORE YOU
BIKE OPERATION
CONDITIONING TROUBLESHOOTING GUIDELINES & MAINTENANCE
TOOLS INCLUDED
cPhillips Screwdriver
c4mm L Wrench
c5mm L Wrench
c5mm T Wrench
c13/15mm Flat Wrench
PARTS INCLUDED
c 1 Console | c 1 Lower Handlebar | ||
c 1 Console Mast | c 1 Upper Handlebar | ||
c 1 Main Frame | c 5 Hardware Bags | ||
c 1 Base Frame | c 1 Rear Stabilizer | ||
c 1 Front Stabilizer Tube | c 1 Seat Guide Rail | ||
c 2 Pedals | c 4 iPod ® Adaptors | ||
c 1 Mast Boot | c 2 Front End Caps | ||
c 1 | Seat Back | c 2 | Rear End Caps |
c 1 | Seat Frame | c 2 | Seat Guide Rail Caps |
c 1 | Water Bottle Holder | c 2 | Leveler Adjusters |
c 1 | Seat Base | c 2 | Levelers |
SCREW (D) 
FRONT END CAP
A)Open HARDWARE BAG FOR STEP 1.
B)Slide REAR END CAPS onto REAR STABILIZER TUBE.
C)Attach 2 LEVELERS and LEVELER ADUSTERS (found in the hardware box) to the bottom of the REAR STABILIZER TUBE and secure tightly.
D)Attach the REAR STABILIZER TUBE to the BASE FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).
E)Slide FRONT END CAPS into FRONT STABILIZER TUBE with wheels facing forward and attach using 2 SCREWS (D) with provided phillips screwdriver.
F)Attach the FRONT STABILIZER TUBE to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).
HARDWARE BAG FOR STEP 1 CONTENTS :
BIKE OPERATION
TROUBLESHOOTING CONDITIONING & MAINTENANCE GUIDELINES
LIMITED WARRANTY
If you have questions or if there are any missing parts, contact Customer Tech Support.
Contact information is located on the back panel of this manual.
BOLT (A) | SPRING WASHER (B) | WASHER (C) | SCREW (D) |
20 mm | 15.4 mm | 18 mm | 10 mm |
Qty: 8 | Qty: 8 | Qty: 8 | Qty: 2 |
LIMITED WARRANTY
B600_Rev.1.6.indd | 7/11/07 1:31:21 PM |