Diamondback PM4360 manual Forward pivots of steparm G-L

2 34

	B-20
	B-21		H-L	H-R
B-14	B-16
				G-15 G-1 G-14
	B-33			G-R
	B-27	B-25	H-R
	B-26		G-L
B-19	H-L

Parts B-14,B-16,B-19,B-19,B-20 & B-21	Parts B-33,B-27,B-26 &	The forward pivots of steparm G-L&
will arive from the factory pre-assembled in the	B-25will arive from the factory	G-Rwill arive from the factory with
carton. Disassemble by removing bolts B-14	pre-assembled on the console	parts G-15, G-1& G-14pre-installed.
and B-21from parts B-16, B-19& B-20.	mast. Remove all components	Remove bolts G-14, pivot caps G-1&
Gather the left (B-19)and right (B-20) lower	except B-25and set aside.	washers G-15from the steparms and
console mast covers and bring together as a	Slide the left (H-L) and right	set aside.
clamshell over the console mast/main frame		Bring the pivots of the left step arm
	(H-R) handlebar assemblies
union. Align covers with the mounting holes
	over the upper pivot. The fit is	(G-L) and handlebar (H-L) together,
and loosely thread the four (4) hex bolts B-21
		sliding the handlebar pivot over the
into place. Do not tighten yet.	designed to be tight so proper
		step arm pivot axle and press into
Positon the lower console mast front cover	alignment is necessary for
		place.
	installation.
(B-16) in place and thread the four (4) hex		Re-install washer G-15, pivot cap G-1
bolts (B-14) through the face and into parts	Re-install washers B-26,pivot
		and fixing bolt G-14. Tighten firmly.
B-19and B-20. Do not over-tighten.	caps B-27and fixing bolts
		Repeat for right-hand side.
Align and tighten all bolts. Do not over-tighten.	B-33. Tighten bolt B-33firmly.

8