Assembly
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom- mended that you place a protective covering on your floor. Note: It is recommended that you apply grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your elliptical trainer on a level flat surface. It is recommended that you place a protective covering on your floor.
Parts (see illustration on previous page)
•1 Front Foot Tube
•2 Upper Handlebars
•2 Lower Handlebars/Link Arms
•2 Pedal arms
•2 Guide Rails
•1 Console Mast
•1 Console Mast Boot
•1 Power Supply
•2 Pedal Arm Sleeves
•2 Crank Boots
•2 Front Upper Handlebar Covers
•2 Back Upper Handlebar Covers
•1 Hardware Pack (contents listed below)
Tools (included)
•4mm Allen Wrench
•5mm Allen Wrench/ Phillips Screw Driver
•13/15mm Flat Wrench
•17mm Wrench
CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @
8